Modular Pipe & Tube Notcher

Notch tubes and pipes at the accurate angle and length.

The 1st notch in a tube or pipe is easily completed with a drill press. The BuildPro® Tube & Pipe Notcher makes alignment and length control of the 2nd notch easy to complete accurately.

Notch Ø25 – Ø63.5mm OD pipes or square tubes at any angle, or off-center. Position the two V-Blocks and clamp as needed.

• The V-Pads have a soft face to protect the pipe or tube surface
• The cutter centrerline is height adjustable to accommodate a wide variety of workpieces
• Adjust cutting angle up to 90º
• Works with 12mm drill
• Accepts hole saw thread sizes: 1/2″-20, 5/8″-18
• 25mm steel shaft
• Double bearing block
• * Mounting hardware not included